Table of Contents
Advertisement
Figure 4-15 Pulling Out the Drive Module
c. Remove the drive from the drive tray:
Remove the four screws securing the drive to the drive tray anticlockwise with
a Phillips screwdriver and take out the drive.
Figure 4-16 Removing Screws Securing the Drive
To install the drive:
1.
Install the drive into the drive tray.
a. Orient the drive into the drive tray with the drive connector toward the rear
end of the tray.
b. Tighten the four screws securing the drive to the drive tray clockwise with
a Phillips screwdriver.
2.
Open the lever. Push the drive module all the way back into the drive bay.
3.
Close the lever to lock the drive module in place.
37
Advertisement
Table of Contents
