Figure 4.102 Management > Lldp > Lldp Port Settings > Lldp Port Configuration; Figure 4.103 Management > Lldp > Lldp Port Settings > Optional Tlvs Selection - Advantech EKI-7706 Series User Manual

The following table describes the items in the previous figure.
Item
Enabled
LLDP PDU Disable
Action
Transmission Interval Select the interval at which frames are transmitted. The default is 30
Holdtime Multiplier
Reinitialization Delay Select the delay length before re-initialization.
Transmit Delay
Apply
The ensuing table for LLDP Global Config lists the following settings (informational
only):
LLDP Enabled, LLDP PDU Disable Action, Transmission Interval, Holdtime Mul-
tiplier, Reinitialization Delay and Transmit Delay
4.9.1.2 LLDP Port Settings
The LLDP Port Settings page allows you to configure the state (enabled or disabled)
of the selected port.
To access this page, click Management > LLDP > LLDP Port Settings.
Figure 4.102 Management > LLDP > LLDP Port Settings > LLDP Port
The following table describes the items in the previous figure.
Item
Port Select
State
Apply
Figure 4.103 Management > LLDP > LLDP Port Settings > Optional TLVs
The following table describes the items in the previous figure.
Item
Port Select
EKI-7706 Series User Manual
Description
Click Enabled or Disabled to set the Global Settings state.
Click to select the LLDP PDU handling action when LLDP is globally
disabled. Options include: Filtered, Bridged, or Flooded.
seconds, and the valid range is 5 to 32768 seconds.
Select the multiplier on the transmit interval to assign to TTL.
Select the delay after an LLDP frame is sent.
Click Apply to save the values and update the screen.
Configuration
Description
Enter the port number associated with the LLDP setting.
Click the drop-down menu to select the LLDP port state.
Click Apply to save the values and update the screen.
Selection
Description
Enter the port number associated with the TLV (optional) selection.
103