Figure 4.23 L2 Switching > Link Aggregation > Lacp Port Settings - Advantech EKI-7706 Series User Manual

The following table describes the items in the previous figure.
Item
System Priority
Apply
The ensuing table for LACP Information lists the following settings (informational
only):
System Priority
4.5.3.5 LACP Port Settings
Link Aggregation Control Protocol (LACP) provides a method to control the bundling
of several physical ports together to form a single logical channel. By configuring the
LACP function, the switch can negotiate an automatic bundling of links by sending
LACP packets to the peer device (also implementing LACP).
To access this page, click L2 Switching > Link Aggregation > LACP Port Settings.
Figure 4.23 L2 Switching > Link Aggregation > LACP Port Settings
The following table describes the items in the previous figure.
Item
Port Select
Priority
Timeout
Mode
Apply
The ensuing table for LACP Port Information lists the following settings
(informational only):
Port Name, Priority, Timeout and Mode
EKI-7706 Series User Manual
Description
Enter the value (1-65535) to designate the LACP system priority.
Click Apply to save the values and update the screen.
Description
Select a port for the LACP Port Settings. The listed available settings
are: FE1-FE4, GE1-GE2.
However, the available settings are dependent on the connected
LACP device and may not be listed as displayed in the current figure.
Enter a variable (1 to 65535) to assign a priority to the defined port.
Click the radio button to select a long or short timeout period.
Click the radio button to select the setting mode: Active or Passive.

Active: Enables LACP unconditionally.

Passive (default): Enables LACP when an LACP device is
detected.
Click Apply to save the values and update the screen.
49