Tcp Modbus; Dhcp Server; Figure 4.110 Management > Tcp Modbus > Tcp Modbus Settings; Figure 4.111 Management > Dhcp Server > Status Settings - Advantech EKI-7428 Series User Manual

4.9.3.3 PoE Port Status
To access this page, click Management > Power Over Ethernet > PoE Port Status.
The ensuing table for PoE Port Status settings are informational only: Port, Current
(mA), Voltage (V), Power (W) and Temp. (°C).
4.9.4

TCP Modbus

The TCP Modbus function allows for client-server communication between a switch
module (server) and a device in the networking running MODBUS client software
(client).
4.9.4.1 TCP Modbus Settings
The TCP Modbus Settings page allows you to configure the modbus function.
To access this page, click Management > TCP Modbus > TCP Modbus Settings.
Figure 4.110 Management > TCP Modbus > TCP Modbus Settings
The following table describes the items in the previous figure.
Item
State
Time out
Apply
The ensuing table for TCP Modbus Status settings are informational only: TCP
Modbus status and TCP Modbus time out.
4.9.5

DHCP Server

The Dynamic Host Configuration Protocol (DHCP) is a network protocol enabling a
server to automatically assign an IP address to a computer from a defined range of
numbers configured for a given network.
4.9.5.1 Status Settings
The Status Settings page allows you to configure the DHCP server mode (enabled or
disabled).
To access this page, click Management > DHCP Server > Status Settings.
Figure 4.111 Management > DHCP Server > Status Settings
Description
Click Disabled or Enabled to set the TCP Modbus state.
Enter the value (1 to 86400) to define the timeout period between
transport time.
Click Apply to save the values and update the screen.
103 EKI-7428 Series User Manual