Table of Contents
Advertisement
RIGOL
Function/Arbitrary Waveform Generator Setting
Clear
Auto
RUN/STOP
Single
1-16
nd Quality Products Online at:
Press GI to enable or disable the output of the [GI] connector on the
front panel; press GII to enable or disable the output of the [GII]
connector on the front panel; and then enter the corresponding
Function/Arbitrary Waveform Generator setting interface. Enable or
disable the status display of the current signal.
Note:
This function is only available for the model installed with the
MSO5000-AWG option.
Press this key to clear all the waveforms on the screen. If the
oscilloscope is in the "RUN" state, new waveforms will continue
being displayed.
Press this key to enable the waveform auto setting function. The
oscilloscope will automatically adjust the vertical scale, horizontal
time base, and trigger mode according to the input signal to realize
optimal waveform display.
Press this key to set the operating state of the oscilloscope to
"RUN" or "STOP". In the "RUN" state, the key is illuminated in
yellow. In the "STOP" state, the key is illuminated in red.
Press this key to set the trigger mode to "Single".
GlobalTestSupply
www.
Chapter 1 Quick Start
MSO5000 User's Guide
.com
sales@GlobalTestSupply.co
Advertisement
Table of Contents
