Rigol MS05000-4CH User Manual page 326

RIGOL
Remote Interface Configuration
MSO5000 series can communicate with the PC via the USB, LAN, or GPIB (requiring
to work with RIGOL's USB-GPIB interface converter) interface. Before using the
remote interfaces, configure the corresponding interface according to the
introductions in the following section.
LAN Configuration
Before using the LAN bus, use a network cable to connect the oscilloscope to your
local area network. The network interface of the oscilloscope is on the rear panel.
Press Utility  IO  LAN to open the LAN Settings interface, as shown in the
following figure. You can view the current network settings and configure the
network parameters.
Network Status
Current IP Config.
Type
MAC Address
VISA Descriptor
IP Config. Type
Network Parameters
Network Status
Different prompts will be displayed according to the current network connection
status.
Network Config Succeeded!

Acquiring IP...

IP Conflict!

Disconnected!

DHCP Config Failed!

Read Status Fail!

Connected!

19-2
nd Quality Products Online at:
Figure 19-1 Network Connection Setting Interface
GlobalTestSupply
www.
Chapter 19 System Utility Function Setting
MSO5000 User's Guide
.com
sales@GlobalTestSupply.co