Ax+B - Rigol MS05000-4CH User Manual

Chapter 6 Operations and Measurements
Auto Measurement
MSO5000 provides auto measurements for 41 waveform parameters, as well as the
statistics and analysis of the measurement results.
Quick Measurement after AUTO
When the oscilloscope is correctly connected and has detected a valid input signal,
press AUTO to enable the waveform auto setting function and open the auto setting
function menu.

displayed automatically on the screen. Meanwhile, the system will make
measurements for the "frequency" of the currently displayed waveforms in a
complete single period. The measurement results are displayed at the bottom of
the screen.

automatically on the screen. Meanwhile, the system will make measurements
for the "frequency" of the currently displayed waveforms in a multiple periods.
The measurement results are displayed at the bottom of the screen.

automatically on the screen. Meanwhile, the system will make measurements
for the "rise time" of the currently displayed rising edge. The measurement
results are displayed at the bottom of the screen. By default, it is intended for
the fast edge signal.

automatically on the screen. Meanwhile, the system will make measurements
for the "fall time" of the currently displayed falling edge. The measurement
results are displayed at the bottom of the screen. By default, it is intended for
the fast edge signal.

Press Option to enter the auto setting function menu.


MSO5000 User's Guide
nd Quality Products Online at:
: Press this key, and then the complete single period of the signal is
: Press this key, and then multiple periods of the signal are displayed
: Press this key, and then one rising edge of the signal is displayed
: Press this key, and then one falling edge of the signal is displayed
: press this key, and the system returns to the last set menu.
Press Lock to lock the AUTO function. To unlock the AUTO function, use the
following two methods:
Method 1: Send the remote command :SYSTem:AUTOscale ON to unlock
the AUTO function.
Method 2: Press Lock again, then a password input dialog box is displayed.
Input the password. By default, there is no password, and pressing OK
directly can unlock the function.
GlobalTestSupply
www. .com
sales@GlobalTestSupply.co
RIGOL
6-27