Chapter 7 Digital Voltmeter (Dvm) And Frequency Counter - Rigol MS05000-4CH User Manual

Chapter 7 Digital Voltmeter (DVM) and Frequency Counter

Note:
DVM measurement.
To Select Measurement Mode
Press Mode in the "DVM" setting menu, then rotate the multifunction knob
select the desired mode, and then press down the knob to select the mode. You can
also press Mode continuously to select the mode or enable the touch screen to tap
the desired mode and select it. The DVM measurement modes include AC RMS, DC,
and AC+DC RMS.
AC RMS:

component removed.
DC: displays the average value of the acquired data.

AC+DC RMS:

To Set the Limits
Press Limits to enter the sub-menu of Limits. Then set the following parameters.
Beeper

Press Beeper continuously to enable or disable the beeper.
Limits Condition Setting

Press When, then rotate the multifunction knob
setting condition. Press down the knob to select it. You can also press When
continuously or enable the touch screen to select it. The limits conditions include
"In Limits" and "Out Limits".

disable the beeper to sound an alarm.

or disable the beeper to sound an alarm.
Upper/Lower Limit Setting

Press Upper, then rotate the multifunction knob
keypad to set the upper limit of the voltage.
Press Lower, then rotate the multifunction knob
keypad to set the lower limit of the voltage.
MSO5000 User's Guide
nd Quality Products Online at:
Even if the analog channel (CH1-CH4) is not enabled, you can still perform the
displays the root-mean-square value of the acquired data, with the DC
displays the root-mean-square value of the acquired data.
In Limits: when the voltage value is within the limits, you can enable or
Out Limits: when the voltage value is outside of the limits, you can enable
GlobalTestSupply
www.
to select the desired limit
or use the pop-up numeric
or use the pop-up numeric
.com
sales@GlobalTestSupply.co
RIGOL
to
7-3