RIGOL
△X: indicates the horizontal spacing between Cursor A and Cursor B.
△Y: indicates the vertical spacing between Cursor A and Cursor B.
1. Adjust Cursor Position
Press AX and rotate the multifunction knob
Cursor A.
Press BX and rotate the multifunction knob
Cursor B.
Press AY and rotate the multifunction knob
Cursor A.
Press BY and rotate the multifunction knob
Cursor B.
Press More ABX and rotate the multifunction knob
value at Cursor A and the X value at Cursor B simultaneously.
Press More ABY and rotate the multifunction knob
value at Cursor A and the Y value at Cursor B simultaneously.
During the adjustment, the measurement results will change accordingly. The
adjustable range is limited within the screen.
Note:
down the multifunction knob
items. If you select either of the items (ABX and ABY), you can press down
the multifunction knob
2. Display Lissajous Legend
This oscilloscope provides the Lissajous schematic diagram under different
frequencies and phase deviation, as shown in Figure 6-4. Press More
Lissajous, then the Lissajous schematic diagram is displayed.
Frequency ratio
between two signals
6-48
nd Quality Products Online at:
If one of the four items (AX, BX, AY, and BY) is selected, you can press
Figure 6-4 Lissajous Schematic Diagram
GlobalTestSupply
www.
Chapter 6 Operations and Measurements
to adjust the X value at
to adjust the X value at
to adjust the Y value at
to adjust the Y value at
continuously to switch among the four
continuously to switch between them.
to adjust the X
to adjust the Y
Phase deviation
between two signals
MSO5000 User's Guide
.com
sales@GlobalTestSupply.co