Lin Trigger (Option) - Rigol MS05000-4CH User Manual

RIGOL
Sync: triggers on the last bit of the sync field.

ID: triggers when the frame with an ID equal to the selected value is detected.

Press ID, then rotate the multifunction knob
keypad to set ID.
Data: triggers when the data that meet the preset conditions are found.

Press Bit X to set the data bit that needs to be operated on. For setting

methods, refer to descriptions in "I2C Trigger (Option)".
Press Bytes, then rotate the multifunction knob

numeric keypad to set the length of the data. Its range is from 1 to 8.
Data&ID: triggers when a frame with a specified ID and data that meet the

preset conditions are both found.
Press Bit X to set the data bit that needs to be operated on. For setting

methods, refer to descriptions in "I2C Trigger (Option)".
Press Bytes, then rotate the multifunction knob

numeric keypad to set the length of the data. Its range is from 1 to 8.
Press ID, then rotate the multifunction knob

numeric keypad to set ID.
Sleep: triggers when the sleep frame is found.

Wakeup: triggers when the wakeup frame is found.

Error: triggers on the specified type of error frame. Press Error Type and select

the desired error type: Sync, Even Odd, or Check Sum.
Protocol Version:
Press More  Version to select the protocol version that matches the signal under
test. The available versions include 1.X and 2.X.
Baud Rate:
Press More  Baud to set the baud rate. Three setting methods are available for
baud rate:
Press Baud, then set the user-defined baud rate with the displayed numeric

keypad.
Press Baud, then rotate the multifunction knob

rate from the available options. The available baud rates include 1.2 kbps, 2.4
kbps, 4.8 kbps, 9.6 kbps, 19.2 kbps, and etc.
Press Baud, then rotate the multifunction knob

small step.
Sample Position:
Sample position is a point within a bit's time. The oscilloscope samples the bit level at
this point. The sample position is represented by the proportion of "the time from the
start of the bit to the sample position" to the "bit time", as shown in the figure below.
5-44
nd Quality Products Online at:
GlobalTestSupply
www.
Chapter 5 To Trigger the Oscilloscope
or use the pop-up numeric
or use the pop-up
or use the pop-up
or use the pop-up
to select the preset baud
to adjust the baud rate at a
MSO5000 User's Guide
.com
sales@GlobalTestSupply.co