Table of Contents
Advertisement
Chapter 19 System Utility Function Setting
RIGOL
To Set the GPIB Address
Before using the GPIB bus to control the oscilloscope, use the USB-GPIB interface
converter (an option that requires to be ordered separately) to extend the GPIB
interface, and then use the GPIB cable to connect the instrument to the PC. Press
Utility IO GPIB, then rotate the multifunction knob
directly to set the
GPIB address or use the pop-up numeric keypad to input the GPIB address. Its
settable range is from 1 to 30. By default, it is 1.
USB Connection
The oscilloscope can communicate with a PC via the USB DEVICE interface on the
rear panel. No parameters are required to be configured.
19-6
MSO5000 User's Guide
GlobalTestSupply
www.
.com
nd Quality Products Online at:
sales@GlobalTestSupply.co
Advertisement
Table of Contents
