Timeout Trigger - Rigol MS05000-4CH User Manual

Chapter 5 To Trigger the Oscilloscope
Trigger Type:
Press Type, and then rotate the multifunction knob
down the knob to select the trigger type. Then, the current trigger setting
information is displayed at the upper-right corner of the screen, as shown in the
figure below. You can also press Type continuously to select the trigger type or
enable the touch screen to tap the desired trigger type and select it.
Source Selection:
Press Source to open the signal source list and select CH1-CH4 or D0-D15. For
details, refer to descriptions in "Trigger Source". The current trigger source is
displayed at the upper-right corner of the screen.
Note:
trigger source, can we obtain a stable trigger.
Edge Type:
Press Slope and rotate the multifunction knob
input signal that starts to pass through the trigger level. You can also press Slope
continuously to enable the touch screen to select the edge type.

the trigger level.

through the trigger level.

trigger level.
Timeout Value:
Timeout value represents the maximum time that the signal remains idle before the
signal passes through the trigger level. Press Timeout, and then rotate the
multifunction knob
Timeout trigger. The available range is from 16 ns to 10 s.
Trigger Mode:
In the trigger control area (Trigger) on the front panel, press Mode to quickly switch
the current trigger mode. For details, refer to descriptions in "Trigger Mode".
Trigger Parameter Setting:
Set the trigger parameter (noise rejection) under this trigger type. For details, refer
to descriptions in "Noise Rejection".
Trigger LEVEL/Threshold Level:
Rotate the Trigger
to "Trigger LEVEL/Threshold Level". The current trigger level/threshold level
value is displayed at the upper-right corner of the screen.
MSO5000 User's Guide
nd Quality Products Online at:
Only when we select the channel (that has been input with signals) as the
Rising: starts timing when the rising edge of the input signal passes through
Falling: starts timing when the falling edge of the input signal passes
Either: starts timing when either edge of the input signal passes through the
or use the pop-up numeric keypad to set the timeout value of
LEVEL knob to adjust the trigger level/threshold level. Refer
GlobalTestSupply
www.
to select "Timeout". Press
to select the edge type of the
.com
sales@GlobalTestSupply.co
RIGOL
5-21