Remote Control - Rigol DG900 Pro Series Quick Manual

Remote Control

9
Remote Control
The following ways of remote control are supported:
• User-defined Programming
Users can program and control the instrument by using the SCPI (Standard
Commands for Programmable Instruments) commands. For details about the
SCPI commands and programming, refer to
series.
• PC Software
You can use the PC software to send SCPI commands to control the instrument
remotely. RIGOL Ultra Sigma is recommended. You can download the software
from RIGOL official website (
Operation Procedures:
-
-
-
• Web Control
This instrument supports Web Control. Connect the instrument to the network,
then input the IP address of the instrument into the address bar of the browser
of your computer. The web control interface is displayed. Click Web Control to
enter the web control page. Then you can view the display of the real-time
interface of the instrument. Through the Web Control method, you can migrant
the device control to the control terminals (e.g. PC, Mobile, iPad, and other smart
terminals) to realize remote control of the instrument. You have to log in before
using the Web Control to modify network settings. When you first log in to the
Web Control, the user name is "admin" and password is "rigol".
This instrument can be connected to the PC via the USB and LAN interface to set up
communication and realize remote control through the PC.
CAUTION
Before connecting the communication cable, please turn off the instrument to avoid
causing damage to the communication interfaces.
DG900 Pro Quick Guide
20
Set up communication between the instrument and PC.
Run Ultra Sigma and search for the instrument resource.
Open the remote command control panel to send commands.
Programming Guide of this product
http://www.rigol.com
).
Copyright ©RIGOL TECHNOLOGIES CO., LTD. All rights reserved.