Table of Contents
Advertisement
Chapter 6 Operations and Measurements
4． Falling Edge Count: The number of falling edges that fall from above the
threshold upper limit to below the threshold lower limit.
Note:
The above measurement items are only available for the analog channels.
The default values for threshold upper limit and threshold low limit are 90% and
10%, respectively. You can press Measure Setting to enter the sub-menu
to set the parameters.
Delay and Phase
1． Delay A →B : indicates the time difference between the threshold middle
values of the rising edge of Source A and that of Source B. Negative delay
indicates that the rising edge of Source A occurred after that of Source B.
2． Delay A →B : indicates the time difference between the threshold middle
values of the falling edge of Source A and that of Source B. Negative delay
MSO5000 User's Guide
nd Quality Products Online at:
1
1
Source A
Source B
GlobalTestSupply
www.
Rising Edge Count = n
2
n
Falling Edge Count = n
2
n
Period
Delay
.com
RIGOL
Threshold Upper Limit
Threshold Lower Limit
Threshold Upper Limit
Threshold Lower Limit
6-31
sales@GlobalTestSupply.co
Advertisement
Table of Contents
