Or" Operation - Rigol MS05000-4CH User Manual

Chapter 6 Operations and Measurements
Table 6-4 Logic "XOR" Operation
A
0
0
1
1
Press Math  Math1  Operator to select "A^B":
Press Operation continuously to enable or disable the "XOR" operation

function.
Press SourceA and SourceB respectively, and rotate the multifunction knob

to select the channel. You can also press SourceA and SourceB continuously
or enable the touch screen to select the channel.
Note:




Press Offset, and then rotate the multifunction knob

offset of the operation results. You can also enable the touch screen and use the
"Drag" gesture to adjust the vertical offset.
Press Size, and then rotate the multifunction knob

size. Press down the knob to select it. You can also press Size continuously or
enable the touch screen to select it. The available sizes include "Small",
"Medium", and "Large".
Press More  AutoScale to adjust the vertical scale and offset of the operation

results to the optimal value according to the current configuration, so as to
better observe.
Press More  Sensitivity to set the sensitivity of the digital signal converted

from the analog signal on the source. For setting methods, refer to descriptions
in "Parameter Setting Method".
Press More  Label to set the label for math operation results. For details,

refer to descriptions in "Math Operation Label".
MSO5000 User's Guide
nd Quality Products Online at:
B
0
1
0
1
to select the channel for SourceA and Source B. Then press down the knob
Only the channels that have been enabled currently can be selected.
If Source A (or Source B) selects CH1, press More  Thre.CH1 to set the
threshold of Source A (or Source B) in logic operation. For setting methods,
refer to descriptions in "Parameter Setting Method".
If Source A (or Source B) selects CH2, press More  Thre.CH2 to set the
threshold of Source A (or Source B) in logic operation. For setting methods,
refer to descriptions in "Parameter Setting Method".
If Source A (or Source B) selects CH3, press More  Thre.CH3 to set the
threshold of Source A (or Source B) in logic operation. For setting methods,
refer to descriptions in "Parameter Setting Method".
If Source A (or Source B) selects CH4, press More  Thre.CH4 to set the
threshold of Source A (or Source B) in logic operation. For setting methods,
refer to descriptions in "Parameter Setting Method".
GlobalTestSupply
www.
A^B
0
1
1
0
to adjust the vertical
to select the waveform
.com
sales@GlobalTestSupply.co
RIGOL
6-13