Remote Control - Rigol DHO800 Series Quick Manual

Remote Control

9
1.888.610.7664
Remote Control
The following ways of remote control are supported:
• User-defined Programming
Users can program and control the instrument by using the SCPI (Standard
Commands for Programmable Instruments) commands. For details about the
SCPI commands and programming, refer to
series.
• PC Software
Users can use the PC software to send commands to control the instrument
remotely. RIGOL Ultra Sigma is recommended. You can download the software
from RIGOL official website
Operation Procedures:
- Set up communication between the instrument and PC.
- Run Ultra Sigma and search for the instrument resource.
- Open the remote command control panel to send commands.
• Web Control
This instrument supports Web Control. Connect the instrument to the network,
then input the IP address of the instrument into the address bar of the browser
of your computer. The web control interface is displayed. Click Web Control to
enter the web control page. Then you can view the display of the real-time
interface of the instrument. Through the Web Control method, you can migrant
the device control to the control terminals (e.g. PC, Mobile, iPad, and other smart
terminals) to realize remote control of the instrument. When you first log in to
the Web Control, the user name is "admin" and password is "rigol".
This instrument can be connected to the PC via the USB and LAN interface to set up
communication and realize remote control through the PC. The remote control can be
realized by using SCPI (Standard Commands for Programmable Instruments)
commands.
CAUTION
Before connecting the communication cable, please turn off the instrument to avoid
causing damage to the communication interfaces.
www.calcert.com
15
10 20
5 25
0 30
Programming Guide of this product
sales@calcert.com