Rigol MS05000-4CH User Manual page 296

RIGOL
been early used in information transmission. Its advantages lie in good performance
in anti-noise and anti-attenuation, and it has been widely used in low and medium
rate of data
1. Set the Modulation Polarity
Press Polarity continuously to select "Positive" or "Negative" of the modulating
waveform to control the frequency output.
2. Set the Modulation Frequency
Press FSK Rate, then rotate the multifunction knob
numeric keypad to set the frequency of the modulation signal. The available
range is from 1 Hz to 50 kHz.
3. Set the Hopping Frequency
Hopping frequency indicates the frequency of the modulating waveform. The
range of the hopping frequency is from 100 mHz to the maximum frequency of
the carrier waveform. By default, it is 1 kHz. Press Hop Freq, then rotate the
multifunction knob
frequency.
Sweep
The built-in Function/Arbitrary Waveform Generator of MSO5000 series oscilloscope
supports the sweep function. In the sweep mode, the Function/Arbitrary Waveform
Generator outputs from the start frequency to the end frequency at a specified
sweep time. MSO5000 series supports 3 sweep modes: Linear, Log, and Step. You
are allowed to set the parameters such as Start Keep, End Keep, and Return Time.
Internal and Manual trigger sources are supported. The sweep output is available for
Sine, Square, Ramp, and Arb (DC excluded) waveforms.
Press Settings  Type, and rotate the multifunction knob
and then press down the knob to select it. You can also press Type continuously or
enable the touch screen to select it.
1. Set the Sweep Type
Press Sweep Type, and rotate the multifunction knob
sweep type, and then press down the knob to select it. You can also press
Sweep Type continuously or enable the touch screen to select it. The available
sweep types include Linear, Log, and Step.
Linear: the frequency of the signal changes linearly.

Log: the frequency of the signal changes in log form.

Step: the frequency of the signal changes with ladder-like step.

17-16
nd Quality Products Online at:
Chapter 17 Function/Arbitrary Waveform Generator (Option)
transmission.
or use the pop-up numeric keypad to set the hopping
GlobalTestSupply
www.
or use the pop-up
to select "Sweep",
to select the desired
MSO5000 User's Guide
.com
sales@GlobalTestSupply.co