Rigol MS05000-4CH User Manual page 329

Chapter 19 System Utility Function Setting
Tip


Apply the Network Parameter Setting
Press Apply to apply the current network parameter setting.
MAC address
For each oscilloscope, the MAC address is unique. When assigning the IP address for
the oscilloscope, the system uses the MAC address to identify the instrument.
VISA Address
Displays the VISA address currently used by the oscilloscope.
To Set mDNS
Press mDNS continuously to enable or disable the multicast Domain Name System
(mDNS). This system is used to provide the function of DNS server for service
discovery in a small network without a DNS server.
To Set HDMI
Sets the status and parameters of the HDMI video output interface on the rear panel.
Note that only when the HDMI interface is connected, can this menu be enabled.
Press HDMI to enter the HDMI setting menu.
Press Output continuously to enable or disable the video output.



Press Resolution to set the screen resolution. The available resolution includes

640x480 , 720x480
MSO5000 User's Guide
nd Quality Products Online at:
When the three IP configuration types are all turned on, the priority of the
parameter configuration from high to low is "DHCP", "Auto IP", and "Static
IP".
The three IP configuration types cannot be all turned off at the same time.
ON: You can connect the instrument to an external display via this interface
to better observe the waveform display clearly from the external display.
OFF: disables the interface.
, and
GlobalTestSupply
www.
1280x720.
.com
sales@GlobalTestSupply.co
RIGOL
19-5