Igmp Settings - ProSoft Technology RLX2-IHW-E User Manual

RLX2-IHx Series ♦ 802.11a, b, g, n
Industrial Hotspots

4.6.1 IGMP Settings

You use the parameters in the IGMP S
Management Protocol parameters of your RLX2-IHx series radio.
RLX2-IHx series radios support IGMP v1 and v2. The IGMP functions are enabled in the
radios by default.
Parameter
IGMP Multicast Filtering
Default Propagation
Action
IGMP Query Generation
IGMP Query Interval
Multicast State Count
ProSoft Technology, Inc.
ETTING
Description
Specifies the state of IGMP multicast filtering (D
Specifies how the radio handles multicast addresses that are not in the
radio's address table.
F - The radio sends unknown multicast packets to all ports.
LOOD
F - The radio filters unknown multicast packets, and does not send
ILTER
them to any ports.
Specifies the state of IGMP query generation in the radio.
D - Disables IGMP query generation.
ISABLED
T I - Enables IGMP query generation. Use IGMP Query
IMED NTERVAL
Interval to specify the query time interval.
Specifies the number of seconds between queries (if the timer is not pre-
empted by a query from another device).
By RFC specification, only one device on a network should generate
IGMP queries. As such, the radio only sends an IGMP query if another
device has not sent a query within the radio's IGMP Q
setting, even if IGMP Q
UERY
Specifies the number of queries the radio generates before a device is
removed from the multicast group on this radio if no response is received
from the device.
Configuring a Radio - Detailed Configuration
group to specify the Internet Group
ISABLED
UERY
G is enabled.
ENERATION
User Manual
or E ).
NABLED
I
NTERVAL
Page 99 of 248