Table of Contents
Advertisement
RLX2-IHx Series ♦ 802.11a, b, g, n
Industrial Hotspots
3.5.4 Configuring a Bridging Client Radio
You can configure RLX2-IHx series radios in Client or Bridging Client modes in the event
that you want to connect to third-party 802.11 Access Points. See Configuring a Client
Radio (page 48) for the differences in the modes. The most straightforward way to test a
Client or Bridging Client mode radio configuration is to use a second PC connected as
the downstream network device from a Client radio. The following example assumes that
there is a second PC, and shows how to connect to the Master radio.
To configure a Bridging Client radio
1
Power up a new radio in the default configuration so that it connects to the Master
radio.
2
Start the IH Browser. After the radio starts, it should appear in the IH Browser.
3
In the IH Browser, assign a temporary IP address to the Repeater radio. See
Assigning a Temporary IP Address (page 37).
4
Log into the radio. See Connecting to the Radio Configuration Interface (page 38).
5
On the B
ASIC
radio to B
RIDGING
6
Click A
PPLY
ProSoft Technology, Inc.
S
tab, in the B
ETTINGS
C
and set the R
LIENT
C
to save the configuration.
HANGES
W
S
ASIC
IRELESS
ETTINGS
N
and SSID accordingly.
ADIO
AME
RLX2-IHx Series Quick Setup
User Manual
group, change the
Page 45 of 248
Advertisement
Table of Contents
Need help?
Do you have a question about the RLX2-IHW-E and is the answer not in the manual?
Questions and answers