Viewing A Radio's Configuration - ProSoft Technology RLX2-IHW-E User Manual

RLX2-IHx Series ♦ 802.11a, b, g, n
Industrial Hotspots
9 Refresh the display in the IH Browser. The radio appears in the IH Browser as a
Client radio.
10 When the Client radio reboots, connect an Ethernet cable from the radio to the
second PC. Wait until the radio registers the MAC address of the PC's network
interface (Client mode only).
11 Ensure that the IP address of the Ethernet interface on the second PC is on the
same subnet as the network for the Client radio. For this example, set the IP address
of the PC interface to 192.168.2.248.
12 Open a command prompt on the second PC, and verify that you can use the Ping
command to ping the IP address of the Master radio.
3.6

Viewing a Radio's Configuration

You can quickly view a radio's configuration.
1 Start the IH Browser.
2 Right-click the radio and then click P
3 If you want to view all the available properties, in the Detailed Information for Radio
dialog box, click M
Note that you cannot change the radio's configuration in this dialog box. If you want
to change the configuration, or view more details, see Configuring a Radio - Getting
Started (page 38) or Configuring a Radio - Detailed Configuration (page 52).
ProSoft Technology, Inc.
ROPERTIES
.
ORE
RLX2-IHx Series Quick Setup
.
User Manual
Page 50 of 248