Configuring A Radio - Getting Started; Connecting To The Radio Configuration Interface - ProSoft Technology RLX2-IHW-E User Manual

RLX2-IHx Series ♦ 802.11a, b, g, n
Industrial Hotspots
3.5

Configuring a Radio - Getting Started

This section describes how to set up RLX2-IHx series radios in a minimal configuration
before deploying them in the permanent installation. See Configuring a Radio - Detailed
Configuration (page 52) for a detailed description of all the configuration parameters
available for your radio.

3.5.1 Connecting to the Radio Configuration Interface

This section describes how to connect to the RLX2 Radio Configuration / Diagnostic web
interface using a web browser such as Internet Explorer or Firefox on your PC or other
network-enabled device.
To connect to the Radio Configuration / Diagnostic web interface
Important: Your computer or other device must be connected to the same network as the RLX2-IHx series
radio.
1 Log into the web interface of the radio. You can do this in any of three ways:
In the IH Browser List view or Topography view, right-click the radio and then
o
click C
ONNECT
In the IH Browser List view or Topography view, double-click the radio.
o
o Open a web browser on your PC, and then in the address bar, type
followed by the IP address for the radio, and then press E
http://192.168.6.10
The login screen appears in the web browser.
2 Enter the password and then click L
have lost the password for the radio, you can reset the radio to its default settings.
See Resetting a RLX2-IHx series Radio (page 180).
ProSoft Technology, Inc.
.
.
OGIN
NTER
. The default password is password. If you
RLX2-IHx Series Quick Setup
User Manual
http:// ,
. For example,
Page 38 of 248