ProSoft Technology RLX2-IHW-E User Manual page 49

RLX2-IHx Series ♦ 802.11a, b, g, n
Industrial Hotspots
To configure a Client radio
1 Power up a new radio in the default configuration so that it connects to the Master
radio.
2 Start the IH Browser. After the radio starts, it should appear in the IH Browser.
3 In the IH Browser, assign a temporary IP address to the Repeater radio. See
Assigning a Temporary IP Address (page 37).
4 Log into the radio. See Connecting to the Radio Configuration Interface (page 38).
5 In the B
ASIC
6 Edit the R
ADIO
7 If you set a temporary IP address in the radio (see Assigning a Temporary IP
Address (page 37)), set the permanent IP address. On the B
the A
CCESS
FOLLOWING
8 Click A
PPLY
ProSoft Technology, Inc.
W S
IRELESS ETTINGS
N if desired.
AME
S group, click O
ETTINGS
IP .
ADDRESS
C to reboot the Radio. A progress bar is displayed during reboot.
HANGES
group, change the radio to C
IP A - DHCP or U
BTAIN DDRESS
RLX2-IHx Series Quick Setup
User Manual
.
LIENT
S tab, in
ASIC ETTINGS
SE THE
Page 49 of 248