Configuring A Radio - Getting Started; Connecting To The Radio Configuration Utility - ProSoft Technology RLX2-IHA User Manual

RLX2-IHx series Quick Setup
User Manual
3.5

Configuring a Radio - Getting Started

This section describes how to set up RLX2-IHx series radios in a minimal
configuration before deploying them in the permanent installation. See
Configuring a Radio - Detailed Configuration (page 57) for a detailed description
of all the configuration parameters available for your radio.

3.5.1 Connecting to the Radio Configuration Utility

This section describes how to connect to the Radio Configuration / Diagnostic
Utility using a web browser such as Internet Explorer or Firefox on your PC or
other network-enabled device.
To connect to the Radio Configuration / Diagnostic Utility
Important: Your computer or other device must be connected to the same network as the RLX2-
IHx series radio.
1 Open the Radio Configuration / Diagnostic Utility for the radio. You can do
this in any of three ways:
o In the IH Browser List view or Topography view, right-click the radio and
then click C
In the IH Browser List view or Topography view, double-click the radio.
o
o Open a web browser on your PC, and then in the address bar, type
http://
For example,
The login screen appears in the web browser.
2 Enter the password and then click L
If you have lost the password for the radio, you can reset the radio to its
default settings. See Resetting a RLX2-IHx series Radio (page 148).
Page 44 of 227
.
ONNECT
, followed by the IP address for the radio, and then press E
http://192.168.6.10
RLX2-IHx series ♦ 802.11a, b, g, n
.
. The default password is password.
OGIN
Industrial Hotspots
.
NTER
ProSoft Technology, Inc.
October 30, 2017