Figure 3-5 Operations>E-Beam Screen When Gun Is On And Hv Is Off; Figure 3-6 Operations E-Beam Screen With Numeric Keypad Displayed - ferrotec Temescal CV-12SLX User Manual

Section 3: Power Supply Operation 3.5 Control of Power Supply from a TemEBeam Controller (EBC)
Figure 3-5 Operations>E-Beam Screen when Gun is On and HV is Off
3.5.4 Setting the Beam Power Level
To set the beam power level, first touch the Change button, then touch the E-Beam button.
The EBC will then display a keypad screen, which you can use to enter a percent-power
setpoint. After you do so and touch Enter to close the keypad, the power supply will ramp up to
that power setpoint. In Figure 3-6, the user has used the keypad to enter 5. Figure 3-7 shows
the Ops>E-Beam screen after the user has closed the numeric keypad, with the beam now
operating at 5% power (= 75 mA). Note that the beam power level can be set or changed either
with beam on or with it off.

Figure 3-6 Operations E-Beam Screen with Numeric Keypad Displayed

0101-8292-0, Rev. C 3-5 CV-12SLX User Manual