ferrotec Temescal CV-12SLX User Manual page 11

This component is designed to be used in an extra-high-voltage system. Only authorized personnel should be
permitted to carry out work on this system.
Prior to any servicing, grounding hooks should be used to short out all high-voltage parts and conductors in both the
vacuum system and the high-voltage power supply. Screens protecting extra-high-voltage conductors should be
removed only if appropriate action has been taken to ensure that extra-high-voltage conductors are dead and cannot be
reenergized inadvertently.
In addition, all personnel should be aware of:
1. The Electricity (Factories Act) Special Regulations (1908 and 1944), in particular, Regulations 18(d) and 28 of the
1980 Regulations, as amended; and
2. The employer's responsibility to set up suitable systems to safeguard the health and safety of employees, according
to the Health & Safety at Work etc. Act (1974).
This equipment will perform in accordance with the instructions and information contained in the user's manual
and its referenced documents when such equipment is installed, operated, and maintained in compliance with
such instructions. The equipment must be checked periodically. Defective equipment shall not be used. Parts
that are broken, missing, plainly worn, distorted, or contaminated, shall be replaced immediately. Should such
repair or replacement become necessary, a telephone or written request for service should be made to Temescal,
Livermore, CA, a division of Ferrotec (USA) Corp.
The equipment, or any of its parts, shall not be altered without the prior written approval of Temescal. The user
and/or purchaser of this equipment shall have the sole responsibility for any malfunction which results from
improper use, faulty maintenance, damage, improper repair, or alteration by any party other than Temescal.
0101-8292-0, Rev. C
Special Amendment for United Kingdom Users
All Electrical Power Sources: Safety Precautions
User Responsibility
ix CV-12SLX User Manual