Epson RC700-D Manual page 6

Before Reading This Manual
NOTE

Do not connect the followings to the TP port of RC700-D. Connecting to the followings
may result in malfunction of the device since the pin assignments are different.
NOTE
For RC700-D, be sure to install the EPSON RC+7.0 to the development PC first, then

connect the development PC and RC700-D with the USB cable.
If RC700-D and the development PC are connected without installing the EPSON RC+7.0
to the development PC, [Add New Hardware Wizard] appears. If this wizard appears, click
the <Cancel> button.
NOTE
Concerning the security support for the network connection:

The network connecting function (Ethernet) on our products assumes the use in the local
network such as the factory LAN network. Do not connect to the external network such
as Internet.
In addition, please take security measure such as for the virus from the network connection
by installing the antivirus software.
NOTE

Security support for the USB memory:
Make sure the USB memory is not infected with virus when connecting to the Controller.
Structure of Robot System
Controller RC700-D can be used with the following version.
Each Manipulator can be used with the following version.
iv
OPTIONAL DEVICE dummy plug
Operation Pendant OP500
Operator Pendant OP500RC
Jog Pad JP500
Teaching Pendant TP-3**
Operator Panel OP1
EPSON RC+ 7.0 Ver.7.5.1B or later
GX4, GX8 series: EPSON RC+ 7.0 Ver.7.5.1B
RC700-D Rev.2