Software Setup And Connection Check - Epson RC700-D Manual

4.2.3 Software Setup and Connection Check

The following is the steps of connecting the development PC and the Controller.
(1) Make sure that EPSON RC+ 7.0 is installed on the Controller connected to the
(2) Connect the development PC and the Controller by the USB cable.
(3) Turn ON the Controller.
(4) Start the software EPSON RC+ 7.0.
(5) Select the EPSON RC+ 7.0 menu-[Setup]-[PC to Controller Communications] to
(6) Select the "No.1 USB" and click the <Connect> button.
(7) After development PC and the Controller connection is completed, "Connected" is
Connection of the development PC and the Controller is completed. Now robot system can be used
from EPSON RC+ 7.0.
RC700-D Rev.2
development PC.
(Install the software when it is not installed.)
display the [PC to Controller Communications] dialog box.
displayed in the [Connection status:]. Make sure that "Connected" is displayed and
click the <Close> button to close the [PC to Controller Communications] dialog box.
Installation 4. First Step
41