Basic Troubleshooting - Lincoln Electric TORCHMATE 5100 User Manual

Machine Faults:
Problem
"Please Enable The Drives" Error Message
Appears
Following Error (AXIS ID)
Drive Fault (AXIS ID)
When the machine is turned on, the computer
and monitor do not power on
The water level does not adjust when clicking
the Up/Down button on the main screen
None of the downdraft doors operate during a
cut
The bevel motors make a light humming noise
Accumove Controller Connecting Screen
Torchmate 5100

Basic Troubleshooting

Release BOTH Emergency Stops buttons and press the
green "ENABLE" button.
Push the red Emergency stop button, move the gantry or
axis to clear the obstruction, release the Emergency stop
button and enable the drives.
Datum the machine.
Push the red Emergency stop button. Release the
Emergency stop button and enable the drives. Datum the
machine. If the error message persists and the axis ID is
X, Y, U, or Z, check Fuse #1 in the electrical cabinet. If the
axis is W or V check Fuse #2 in the electrical cabinet.
Check power at the supply side. Verify breakers and any
GFCI outlets. Check Fuse #4 in the electrical cabinet.
Restore Shop Air to the tables manifold.
Restore Shop Air to the tables manifold.
The motors apply power to hold their position in normal
operation. This will be heard as an audible hum.
If this screen is displayed for longer than 1 minute, turn
off power to the machine for 1 minute. Turn the power
back on. If the same condition exists, check Fuse #3 inside
the electrical cabinet.
Solution
70