Lincoln Electric TORCHMATE 5100 User Manual page 71

Create a Bevel Cut:
In the CENTER, enter the size of
material you have for the NEST.
Enter 1 in the # OF SHEETS.
Press NEST SETTINGS at the top of the screen.
This will open the NEST properties. In the upper right, verify that the POST is set to your plasma power supply. At the
bottom of the Nest Settings, verify the AMPS and AIR for the POST to write the CUT SETTINGS for your part.
Press NEST.
JOB MANAGER will open and display your nest along with the part in the display.
Press POST PROCESS.
59
User Guide