Lincoln Electric TORCHMATE 5100 User Manual page 11

Unpacking: FineLine 170HD / 300HD
The 5100 with the FineLine HD systems will be professionally installed at a customers location. Due to
the weight of the power supplies, 700lbs+, there are requiremnts that need to be met when handling the
equipment. For complete instructions, see the FineLine Operators Manual.
The FineLine 170HD and Fineline 300HD should be lifted by a forklift, pallet jack or crane. In order to prevent
damaging the Power Supply when lifting with a forklift or pallet jack, the forks should be of adequate length to
protrude on the far side of the Power Supply.
If lifting by lifting eye, ensure the following:
• Material handling equipment must comply with local
and national laws and regulations. The personnel
involved in the move must be properly trained and
qualified to use such equipment.
• All power supply covers must be securely installed.
• Lift slowly -not more than 8 in. (203.2mm) high- to
ensure even weight distribution.
• Move slowly to prevent uncontrollable acceleration/
deceleration.
Unboxing and Leveling
1. Place the FineLine Power Supply on a flat and level
surface.
2. Remove the wooden crate and plastic bag
surrounding the Power Supply.
3. Remove the rear input cover to find the operator's
manual and accessories.
4. Remove the eight screws and washers and four
mounting plates between power supply and skid.
5. Lift the machine off of the skid.
6. With the machine properly lifted and secured,
carefully thread each leveling foot in place while
keeping the jam nut between the foot and the base.
Be careful not to cross thread the feet and be sure
the threads are fully engaged with the base. Roughly
adjust all four feet to the same desired height.
7. Set the machine on the floor, adjust the feet to level
the machine, and then tighten the jam nut against
the base to lock their position.
Lifting Eye
Tighten to Lock Position
Height Adjustment
xi
User Guide