Unpacking Your New Machine - Lincoln Electric TORCHMATE 5100 User Manual

Unpacking Your New Machine

Your new Torchmate® 5100 CNC machine is delivered assembled, but you will need to remove the shipping
material and gantry locks before operation. Verify all items have been shipped without damage before you
accept the order from the shipping company. Notify Lincoln Electric® at (775) 673-2200 to report any shipping
damages. Your machine was fully tested at the factory, and a metal cut sample can be found in the cutting bed
of the machine.
Unpackaging your Torchmate 5100 is a simple process. Your machine will arrive on a flatbed truck and wrapped in
plastic. Use a razor knife to remove the wrap from the machine. Inspect the contents and verify that there is no damage
to the machine or its contents in the bed. If damaged, do not accept the shipment and contact Lincoln Electric Cutting
Systems.
The plasma unit, along with all of the connection cables will be secured to a separate pallet. To remove the plasma
power supply from the pallet, team lift or forklift the plasma power supply and set aside until the machine is placed in
its final operational location. The plasma unit will sit on the floor near the cable carrier exit on the monitor side.
At minimum, a 6,600 lb.+ forklift with a 48" load center is required to place the machine in its operational position. Use
the forklift access ports on the machine. Do not lift the machine from the cable carrier side.
Torchmate 5100 models are shipped with factory
installed gantry locks. The yellow locking devices
must be removed before the machine can be made
operational. DO NOT replace the bolts after removing
the yellow locking devices as this will cause irreversible
damage to the gantry.
DETAIL B
B
DETAIL C
iii
A
Do Not Fork Lift From
Cable Carrier Side Of
Machine!
C
DETAIL A
User Guide