Lincoln Electric TORCHMATE 5100 User Manual page 21

Lincoln Electric FineLine® High Definition Power Supplies have a larger power box and a gas controller to mix
several different types of gases utilized in HD plasma cutting. The placement of these products with the 5100
must be within 6' of the cable chain's end. This also determines the location of incoming power to the FineLine
plasma cutter, and the termination of gas leads to the plasma cutter.
The FineLine plasma cutting system requires a minimum of 100% oxygen source, 100% nitrogen source,
and shop air for steel and aluminum cutting. Consult the FineLine users manual for gas pressure and volume
requirements.
5100 HD
167"
Load From
This Side
Site Preparation - HD
14" Duct, Downdraft
Models Only
113.25"
MAINTAIN WORK AREA
15' Power Cord, Nema 5-15P
Earth Ground
33"
FineLine
Power
37"
Supply
Locate power supply
within 6' of table cable
chain.
Operator
Console
9
Shop Air Supply
(provided by customer)
Gases
(provided by customer)
laced within 15' of FineLine
p
Incoming AC power
for plasma cutter,
shop air supply, and
termination of gas
hoses from supply
User Guide