Lincoln Electric TORCHMATE 5100 User Manual page 6

Unpacking: Electrical Connections
Internally the 5100 comes pre-wired and ready to run. All systems are test-fired and disconnected at the facility
before packaging and shipping. For shipping purposes, the plasma power supply is disconnected from the system
and will require a connection to the machine once installed. The table has a single input power cord with a 120v
NEMA 5-15P plug that powers the table and computer/monitor. Connections should be made in accordance with all
local and national electrical codes. Failure to do so may result in bodily injury or death.
5100 - Table Power connections:
Attach the supplied 120v NEMA 5-15P plug into a 120vAC 15A wall outlet. This will power the electronics and table
functions.
Electrical Bulkhead
5100 - Pneumatic connections:
The 1/4" industrial quick disconnect input on the bulkhead will distribute the air to the plasma power supply along
with table operations. Any accessories will also be provided shop air by tapping into the two output 1/4" tubing
push-connects
Torchmate 5100
All electrical, air, and interface connections
to the machine will be off of the BULKHEAD
ETH 0 ETH 1 P1
EXT. NETWORK FLEXNET PLASMA
INTERFACE
Star Ground
1/4" O.D. Tubing
Push Connect
(for accessories)
1/4" Industrial Quick
1/4" Industrial Quick Disconnect
Shop Air input
Disconnect to Plasma
Cutter
vi
Bottom
View
P2 P3 P4
POWER
RESERVED CAN / E-STOP EXTERNAL
ENTRY
INTERFACE V-F BOX
Front
View
120v Power Cord
15', NEMA 5-15P