Lincoln Electric TORCHMATE 5100 User Manual page 7

The FlexCut 125 will have two barrel connectors to attach to the bulkhead. When moving your FlexCut 125, use
a team lift or hoist. A 10 ft (3m) power cord is provided with the FlexCut 125. Three Phase Input Only. Connect
green lead to ground per National Electric Code.
For further information, please reference the FlexCut 125 user guide - IM10300.
Connect black, red and white leads to power. In
all cases, the green or green/yellow grounding
wire must be connected to the grounding pin
of the plug, usually identified by a green screw.
Attachment plugs must comply with the Standard
for Attachment Plugs and Receptacles, UL498.
The product is considered acceptable for use only
when an attachment plug as specified is properly
attached to the supply cord.
INPUT CORD STRAIN RELIEF
ROUTE INPUT CORD THROUGH RELIEF
AND TWIST NUT TO TIGHTEN
GROUND CONNECTION
CONNECT GROUND LEAD PER LOCAL
AND NATIONAL ELECTRIC CODE
Air or Gas Inlet (1/4"
Female Quick Connect)
from bulkhead:
Unpacking: FlexCut 125
POWER CONNECTION BLOCK
CONNECT EACH PHASE OF A
THREE PHASE CONDUCTOR HERE
Star Ground
P1
ETH 0 ETH 1 P2
PLASMA
EXT. NETWORK FLEXNET RESERVED
INTERFACE
Star Ground
3-ph
Main Power
CNC Interface
Cable
Main Power
Switch
Torch Lead
Work (ground)
Connection to
Star
FlexCut 125
Back
BOTTOM
VIEW
P3 P4
POWER
CAN AUXILARY
ENTRY
INTERFACE I/O
FRONT
VIEW
120v Connection
vii
FlexCut 125
Front
User Guide