Crete a Bevel Cut:
The BROWSE window will open. Locate and select the
job; the file will have a .DRW extension.
Press OPEN.
The JOB MANAGER will show the loaded job and display the tool path to the job in the lower left. In the ITEM LIST,
changing the QUANTITY will allow for irregular part nesting based on the sheet size entered.
Press NEST SETTINGS at the top of
the screen.
This will open the NEST properties.
In the upper left, verify that the
POST is set to your Plasma power
supply. At the bottom of the NEST
SETTINGS, verify the AMPS and AIR.
58
Torchmate 5100