Create a Bevel Cut:
After pressing POST PROCESS, the POST SETTINGS dialog will open.
This will state the POST to use in a drop-down dialog. Verify that the plasma power supply is correct.
The default PATH is C:\DOWNLOADS
To save to the HOT FOLDER in VMD, change the PATH to C:\CONTROLLER DATA\JOBS
To save to a Flash Drive, or another drive, press the three dots and open the BROWSE dialog.
Your FILE will be named numerically based on the NESTED PLATES SHEET NAME.
In this example, the cut file would be named 0000200001.GM
In the TOP tool bar area, press CLOSE JOB.
The NESTED JOB MANAGER will display. Press the X in the upper right to exit out of the software.
The file can then be brought into VMD for cutting.
60
Torchmate 5100