Lincoln Electric TORCHMATE 5100 User Manual page 53

Running a Job:
Plate Setup:
1. Press PLATE SETUP. Use the jog keys in PLATE SETUP to move the torch
body to the lower left corner of the material you are planning to cut.
2. Press SET PLATE ORIGIN. This establishes the PROGRAM ZERO of the
program, or the ABSOLUTE X 0: Y 0 of the job.
3. Press CLOSE.
4. On the bottom of the screen, toggle to DRY RUN. Press RUN JOB. This
will 'simulate' the job loaded without firing the plasma torch.
5. If satisfied with the Dry Run and the machine movements, toggle DRY
RUN to ACTIVE RUN to cut the job loaded.
6. Press RUN JOB.
If you find that the machine is moving too fast for the material, you can alter
the feedrate by using the FEEDRATE OVERRIDE % slider bar.
By default, the slider is set to 100%. To slow down based on percentage, move
the slider to the left. To speed up the feedrate, slide past 100%.
41
User Guide