Intensity - MICRO-EPSILON colorSENSOR CFO Operating Instructions Manual

Operation
Before
Menu mode
Menu mode
5.3.3
System adjustment is required after installing the measuring system and, typically, following any change in
the optical conditions, such as:
- Distances
- Alignment
- Lenses
- Sensor replacement
i
In addition to the illumination intensity, the sensitivity of the photo receiver is also indirectly adjusted during
this process.
colorSENSOR CFO
After
Save all changes
/ return to oper-
ating mode
Discard all
changes / return
to operating
mode

Intensity

Match the intensity settings of the system to the brightest object expected.
Each time the optical conditions are adjusted, the intensity settings of the system should be readjusted
to the brightest object to be expected.
INT
TEACH
AUTO
The intensity menu is then active.
CLR OPT
GATE 1
TEACH 2
HOLD 3
ESC
MULTI 4
TOL
CLASSIFY 5
SPHERE 6
CYLINDER 7
BOX 8
Action
Press (hold) the ENTER key for more than 2 sec. (INT) to
save all changes made and return to the operating mode.
Press (hold) the ESC key (TOL) for more than 2 sec. to
throw out all changes and return to the operating mode
without saving.
Starting in the operating mode, first select the intensity menu by pressing
(holding) the INT key for more than 2 sec.
Page 45