Digital I/O (I/O) - MICRO-EPSILON colorSENSOR CFO Operating Instructions Manual

Installation and Assembly
4.3.3
The five push-pull switching outputs on the 8-pin connector I/O 1 are electrically connected to the power sup-
ply. The switching output logic level depends on the supply voltage V
Use:
- Direct for a total of 8 individual colors or binary for 254 color groups.
The switching state zero is not used to ensure reliable test performance in the face of a discontinuity.
The switching state all switched is recommended as the standard error output.
The cable shield is connected to the housing.
All GND conductors are interconnected with one another and to the supply voltage ground.
Micro-Epsilon recommends the optionally available CAB-M12-8P-St-ge
Pin
1
2
3
4
5
6
7
8
Fig. 14 I/O Digital I/O Connector
The color outputs can be programmed using the keypad.
1) Applies only for colorSENSOR CFO200.
2) Conductor color CAB-M12-8P-St-ge
colorSENSOR CFO

Digital I/O (I/O)

Connect the cable shield to the evaluation unit.
Use a shielded cable with a length < 30 m.
Color Function Description
2
IN1 Trigger input
White
Brown IN2 Trigger input
Green IN3 Trigger input
Yellow OUT3 Switching output (NPN/PNP/PP)
Gray OUT4 Switching output (NPN/PNP/PP)
Pink OUT5 Switching output (NPN/PNP/PP)
Blue OUT6 Switching output (NPN/PNP/PP)
Red OUT7 Switching output (NPN/PNP/PP)
connected.
+
cable, see A 1.
2
1
7
View of control-
Pin sequence, 8-pin
ler
cable connector,
flange socket
view of solder side
3
4
8
5
6
Page 31