MICRO-EPSILON colorSENSOR CFO Operating Instructions Manual page 106

Operation
Trigger input
No function
Switching the outputs
Teaching
colors
Fields with gray
background re-
quire a selection.
Fields with dark
Val-
border require
ue
entry of a value.
colorSENSOR CFO
High level No function,
Switch outputs,
Teach color,
Low level
Sensor keys,
Run autogain,
Remove all colors,
Rising edge
Remove all color groups
and colors
Falling edge
The signal at the outputs is updated when the corresponding input sig-
nal is set. For example, if the outputs are switched when the signal level
is high, the update will continue as long as the level is present.
i
The measured values are sent via the interfaces at 15 Hz regard-
less of this setting.
New Here, a new color group with the color currently detected by the sensor
color group is created for each trigger event.
Output Here, the new color is learned to the color group with the selected
(color group) output configuration, regardless of whether this color group already ex-
ists or not. This allows, for example, to always learn the color to output
1 (OUT0 on high). With this setting, you can then additionally select
whether all previous colors in this group should be deleted beforehand
or whether additional colors should be learned.
Color group: If color groups have already been learned, then colors can also be
#Name taught to an existing color group. All color groups that have already
been learned can be selected under this function. If no color group has
been learned yet, this function is not available for selection. With this
setting, you can also select whether all previous colors in this group are
to be deleted beforehand or whether they are to be added.
Determines one or several functions that
are executed when a trigger event occurs.
The following trigger events are possible:
Level High, Level Low, Rising edge, Fall-
ing edge
Page 106