Intensity - MICRO-EPSILON colorSENSOR CFO Series Instruction Manual

Operation
5.4.1
Adjustment of the sensor level is required after installing the sensor and, typically, following any change in the
optical conditions, such as:
- Distances
- Alignment
- Lenses
Adjustment of the sensor level is required after installing the sensor and, typically, following any change in the
optical conditions, such as:
In addition to the illumination intensity the sensitivity of the photo receiver is also indirectly adjusted during
this process.
colorSENSOR CFO

Intensity

When adapting the intensity settings, always aim the sensor at the brightest specimen anticipated.
INT
TEACH
AUTO
The intensity menu is then active.
CLR
OPT
GATE 1
TEACH 2
3
HOLD
ESC
MULTI 4
TOL
CLASSIFY 5
SPHERE 6
CYLINDER 7
BOX 8
The number of illuminated output LEDs provides for visualization of the relative
intensity currently being received by the sensor.
INT
TEACH
i
AUTO
CLR OPT
GATE 1
TEACH 2
HOLD 3
ESC
In the delivery state the No color detected output is set to All high.
MULTI 4
TOL
5
CLASSIFY
Therefore: All output LEDs 1 - 8 (with CFO100 all output LEDs 1 - 3) illuminate
6
SPHERE
CYLINDER 7
simultaneously when a color is not detected.
BOX 8
Starting in the operating mode, first select the intensity menu by depressing
(holding down) the INT key for longer than 2 sec.
All output LEDs 1 - 8 flash on and off simultaneously to indicate overmodu-
lation of the photo receiver.
Page 37