Factory Reset - MICRO-EPSILON colorSENSOR CFO Operating Instructions Manual

Operation
i
You can then load your previously saved
5.7
A factory reset can be triggered as follows:
Avoid pressing any other keys during this procedure. Otherwise the process can become stuck in an unde-
NOTICE
fined state.
> Damage of the controller
The controller then starts resetting to factory
well as all firmware updates performed in the meantime are discarded. Resetting requires approx. 5 minutes.
In the event of an error, e.g. interrupted power supply, the reset is continued during the next restart. No color
recognition is indicated and no entries are possible during the reset operation. Key actuation is acknowl-
edged by error flashing (3x100 / 300 ms).
Indicators
Output LEDs:
Key LEDs:
Power LED:
Key-lock LED:
colorSENSOR CFO
After a firmware update, it is recommended to reset the sensor, as the factory settings may also have
changed, see 5.6.8.5.

Factory Reset

Disconnect the controller from the power supply.
Hold the INT and ESC keys depressed.
Switch the power supply back on.
Keep the keys pressed for > 2 seconds and then release them as soon as the LEDs start flashing.
Pulsating progress bar (indeterminate progress bar)
Not illuminated
Illuminated continuously
Illuminated continuously
parameters, see 5.6.8.4 back onto the controller.
defaults, see A 2. During this operation all controller settings as
Page 123