Outputs - MICRO-EPSILON colorSENSOR CFO Operating Instructions Manual

Operation
5.6.7
The switching characteristics of the outputs can be set in this menu point.
Fig. 54 Outputs window
Here it is possible to select between OFF, NPN, PNP and PUSH-PULL. More details on the output con-
figuration, see
Detection
The outputs to be physically switched for the recognized color can be set in the color table and the corre-
sponding color
The switching
parameters (L & a & b), the color is then considered to be recognized.
If the color is not within the specified parameters, the output for Color not recognized becomes active.
In the delivery state this is all outputs at high.
colorSENSOR CFO

Outputs

Go to the menu Settings > Outputs.
4.3.6. The outputs to be physically switched for Color not recognized can be set in the
profile, see 5.6.3.2.
group, see 5.6.5.
output, see Fig. 55, becomes active when the measured color is within the specified tolerance
Fig. 55 Switching behavior
Page 109