Table of Contents
Advertisement
Chapter 2
Target interface connectors
DSTREAM-ST has an Arm JTAG 20 connector, a CoreSight 20 connector, an auxiliary connector, and a
user I/O connector.
The Parallel Trace probe provides an additional MIPI-60 connector.
To adapt debug connectors for other target connectors, you can use cables and adapter boards. Some of
these cables and adapter boards are supplied with the debug unit. Others can be requested from Arm. For
a list of provided adapters, see the
If your target system uses a connector which is not currently supported, and you are considering a
volume order of Arm debug units,
supply a compatible adapter on a fast-turn, prototype basis.
All connector pinouts in this chapter are shown as they would appear on the target board.
It contains the following sections:
•
2.1 Target connector selection guide on page
•
2.2 Arm JTAG 20 connector on page
•
2.3 CoreSight
•
2.4 CoreSight
•
2.5 TI JTAG 14 connector on page
•
2.6 Mictor 38 connector on page
•
2.7 Dual Mictor connectors on page
•
2.8 MIPI 34 connector on page
•
2.9 MIPI 60 connector on page
•
2.10 Auxiliary (AUX) connector on page
101714_0100_02_en
Arm DSTREAM-PT Getting Started
contact Arm support
Note
10 connector on page
™
20 connector on page
™
2-40.
2-45.
2-47.
Copyright © 2019 Arm Limited or its affiliates. All rights reserved.
with your requirements. Arm might be able to
2-34.
2-35.
2-36.
2-37.
2-39.
2-42.
2-49.
Non-Confidential
Guide.
2-32
Advertisement
Table of Contents
