Page 2
This document is intended only to assist the reader in the use of the product. ARM shall not be liable for any loss or damage arising from the use of any information in this document, or any error or omission in such information, or any incorrect use of the product.
Contents ARM DS-5 Setting up the ARM DSTREAM Hardware Chapter 1 Conventions and feedback Chapter 2 Introduction to ARM DSTREAM About DSTREAM ..................... 2-2 DSTREAM product contents ..................2-3 DSTREAM availability and compatibility ..............2-4 The DSTREAM unit ....................2-5 The DSTREAM probe ....................
Highlights important notes, introduces special terminology, denotes internal cross-references, and citations. bold Highlights interface elements, such as menu names. Also used for emphasis in descriptive lists, where appropriate, and for ARM ® processor signal names. Feedback on this product If you have any comments and suggestions about this product, contact your supplier and give: •...
Page 6
ARM also welcomes general suggestions for additions and improvements. ARM periodically provides updates and corrections to its documentation on the ARM Information Center, together with knowledge articles and Frequently Asked Questions (FAQs). Other information •...
ARM processor-based hardware target. It enables you to connect a software debugger to an ARM processor-based target using a hardware interface such as JTAG or Serial Wire Debug (SWD). It also enables the collection of trace from the device for non-intrusive debug and code optimization.
Introduction to ARM DSTREAM DSTREAM availability and compatibility DSTREAM is available from ARM and its resellers. Contact ARM directly regarding OEM licenses. See the documentation for your ARM debug tools to determine the compatibility with DSTREAM. DSTREAM provides: • The ability to access the target.
The available connectors are: ARM JTAG 14 This is an older ARM connector standard which is now rarely used. TI JTAG 14 This is a Texas Instruments connector standard used by most TI-based target boards.
Installing the USB drivers for your debug hardware unit When you connect your debug hardware unit to a USB port for the first time after installing ARM DS-5, the Found New Hardware Wizard is displayed. To install the USB drivers for your debug hardware unit: Click Next.
ARM processor. These are called templates. You can update the DSTREAM firmware using the installed Update utility. DSTREAM firmware updates are supplied with ARM DS-5. You must ensure that you align the firmware updates with the same version used by the tools. 2.7.1...
The debug software provides support for debugging on a wide range of ARM processors. To see a list of supported processors, open the installed Update utility, connect to your debug hardware, and expand the Templates tree and sub-trees.
Chapter 3 System requirements for using ARM DSTREAM The following topics describe the system requirements for ARM DSTREAM , and how to ® ™ connect the DSTREAM unit to your host computer and target system: • Requirements for connecting the DSTREAM unit on page 3-2 •...
You can stop trace captured by using a trigger condition or a manual stop, and you can configure the amount of trace captured after a trigger event. Note See the DS-5 debugger documentation for details of the trace capabilities, and for configuring trace. 3.4.1 See also Tasks •...
Need help?
Do you have a question about the DS-5 and is the answer not in the manual?
Questions and answers