Table of Contents
Advertisement
2.7
Dual Mictor connectors
Two separate Mictor 38 connectors can be used to support JTAG debug, Serial Wire Debug, SWO trace,
and up to 32-bit wide continuous-mode TPIU trace.
The center ground pins of the Mictor sockets must be solder-pasted on the same side of the PCB as the
connector. If you do not solder-paste on the same side of the PCB as the connector, it might cause
mechanical or signal integrity issues.
Typically, the sockets used are a 2-767004-2 from TE Connectivity.
To use these connectors with DSTREAM-PT, the supplied 32-bit Mictor adapter must be used in
conjunction with the MIPI-60 cable.
101714_0100_02_en
Warning
Copyright © 2019 Arm Limited or its affiliates. All rights reserved.
Non-Confidential
2 Target interface connectors
2.7 Dual Mictor connectors
2-42
Advertisement
Table of Contents
