1.9
Typical SWD circuit
A typical SWD circuit:
To improve signal integrity, it is good practice to provide an impedance-matching resistor on the
SWDIO and SWO outputs of the processor. The value of these resistors, added to the impedance of the
driver, must be approximately equal to 50Ω.
101714_0100_02_en
Note
Copyright © 2019 Arm Limited or its affiliates. All rights reserved.
Debug
Connector
VTREF
SWDIO
SWCLK
SWO
nSRST
GND
Non-Confidential
1 Debug and trace interface
1.9 Typical SWD circuit
VDD
10K
10K
10K
22R
SWDIO
SWCLK
SWO
22R
nRESET
10K
Figure 1-17 Typical SWD circuit
Target
Device
1-30