Diagnostics; Error Messages - Jetter JetWeb JetMove 203-230 User Manual

JetMove 203-230
9
9.1
Error Type of Error
Number
F 00 Hardware error
F 01 Internal voltage
supply error
F 02 One mains phase
has failed
(is only active in
case of a 3-phase
connection)
F 03 Motor cable fault
F 04 DC link
overvoltage
Jetter AG

Diagnostics

Error Messages

Note!
In the case of an error message, the letter "F" and two successive numbers
appear on the 7-segment display every second.
Error Message Table JetMove 203-230
Description
Internal hardware
defect
One or more power
supply voltages are
beyond their limits
Failure of one of the
mains phases
The motor cable is
broken
Please note: The
motor cable is tested
when the drive
controller is enabled
for the first time
A DC link voltage
of> 480 V has been
detected
Effect Error Correction
– Immediate – Cut drive controller
pulse disable from power lines
– Return the amplifier
for repair
– Immediate – Cut drive controller
pulse disable from power lines
– Return the amplifier
for repair
– Immediate – Check fuses and
pulse disable wiring
– Acknowledge failure
– Immediate – Check the motor
pulse disable cable connections
– Acknowledge failure
– Immediate – Check input voltage
pulse disable supply
– If the motor is used as
a generator, reduce
the regenerating
power
– Acknowledge failure
9.1 Error Messages
65