Table of Contents
Advertisement
2 Installing the JetMove 203-230
2.6
Warning
26
Safety Instructions for
Commissioning
HAZARD caused by high operating voltage and electric
shock!
Extremely hazardous voltages of up to DC 480 V may
occur!
Please observe the following precautions in order to avoid muscle cramps, burns,
unconsciousness, respiratory standstill, etc., and death:
Have commissioning jobs carried out by qualified personnel only, see
chapter 1.1.3 "Who may operate the servo amplifier JetMove 203-230?",
page 10.
Before switching on
Reattach dismantled protective equipment and check it for proper
functioning.
By doing so, you will prevent accidents resulting from movable parts.
Secure the servo amplifier JetMove 203-230 against accidental contact
with conductive parts and components.
Only connect devices or electrical components to the signal lines of the
digital servo amplifier JetMove 203-230 (Enable, Limit+/-, REF, BRAKE 1
and BRAKE 2) that have been sufficiently isolated against the connected
electric circuits. These signal lines may only be connected with units that
have got the ground potential of the DC 24 V power supply.
Accordingly, do only connect resolver, HIPERFACE and servo motor with
the servo amplifier, if they have been sufficiently isolated from the
connected power supply.
The digital servo amplifier JetMove 203-230 has got a leakage current
greater than 3.5 mA. In order to avoid electric shocks, a second protective
earth conductor will be required.
For this, the measures listed in chapter 1.2.3 "Earthing procedure", page
13 must be taken.
Each commissioning, even a short functional test, must always be carried
out with a PE bus correctly connected.
JetWeb
Jetter AG
Advertisement
Table of Contents
